Engineering

Engineering Transfer program

UFV offers the first year of the Bachelor of Applied Science (Engineering) degree program for students wishing to transfer to the University of British Columbia or the University of Victoria. Upon completion of the UFV program, students may be allowed to enter the second-year Engineering programs at UBC and UVic without any additional qualifying courses, providing they meet the entrance requirements for the program at these institutions.

Students transferring to UBC or UVic from the UFV program with the minimum required GPA may be admitted to the UBC/UVic second-year program. Once admitted, all students, regardless of their first-year institution, then compete for seats in different specialties based on their GPA; popular specialties have higher GPA requirements than the entrance GPA. UBC also allows admission from General Sciences, but may require a higher entrance GPA.

Entrance requirements

Admission to the Engineering Transfer Program (ETP) is based on the following:

1. B.C. secondary school graduation or equivalent.
2. Pre-Calculus 12 with a grade of B or better.
3. Chemistry 12.
4. Physics 11. Physics 12 is strongly recommended.
5. A minimum grade of C+ in English Studies 12 or English First Peoples 12 (see Note 1), or one of the other prerequisites for ENGL 105.

   Note 1: Students may also present English 12, English Literature 12, English 12 First Peoples, AP English, IB English A (standard level or higher level), or out-of-province equivalent.

Note 2: Applicants who are currently completing the course requirements must submit an interim transcript with their application.

Students offered conditional admission will have their files reviewed after receipt of final grades. Those falling below the completive minimum established for that year will be offered a place in the Bachelor of Science, provided they meet the BSc entrance requirements.

Applicants must provide an email address and are expected to check their email regularly (usually starting in February). Students must respond to information sent to them in order to keep their application active.

Note 1: Due to the demand for this program, UFV students must enrol in at least 12 of the program courses in two consecutive semesters. Admitted ETP students who do not enrol in the full program will be moved to the Bachelor of Science, provided they meet the BSc entrance requirements. Students who have already completed two or more program courses or who intend to spend two years at UFV should apply to the Bachelor of Science program instead. Students should see an Academic Advisor for more details.

Note 2: To successfully complete the Engineering Transfer program, students must be academically strong. This program is best suited to students with a B average or better.

When to apply

Applications are accepted for entrance to the Fall semester only. For application deadlines, see Specific intake application process.

How to apply

1. Apply online at ufv.ca/admissions/apply.

   Additional documents required for a complete application:

   • Proof of B.C. secondary school graduation or equivalent.
   • Official transcripts (or interim transcripts) showing grade/course achievement as per entrance requirements. To be considered official, transcripts must be sent directly to UFV from the originating institution; see the Transfer Credit section for details.
2. In the spring, applicants will be notified about attending the interview/information session.
3. Upon admission to the program applicants will be provided with registration information. A deposit is required prior to registration (see the Fees and Other Costs section) and will be applied toward tuition fees.
4. In cases where interim transcripts are submitted, an admission decision may be made conditional upon completion of academic requirements. Proof of completion of entrance requirements is due by the end of the first week in August.

Basis for admission decision

Seats will be competitively awarded based on the average of Chemistry 12, Physics 12, and Pre-Calculus 12. If these courses are not completed at the time of application, then the grades for the corresponding Grade 11 courses will be substituted. In all cases, if both the Grade 11 and 12 courses have been completed, then the better of the two grades will be used to calculate the GPA for admission. Students who do not have at least a B average in these three courses will not normally be considered for admission. Conditional admission may be granted to students with courses in progress at the time of application.

Reserved seats

Students who meet the entrance requirements and register in six of the required engineering courses each semester will have reserved seats in the program's core courses. Students who are admitted to the Engineering program but register in fewer than six courses may not claim reserved seats. Engineering reserved seat status is only available for first-year courses and only for first-year students.

Program duration

The Engineering Transfer program is one year in duration.

Program outline

The following order of courses is used so all the prerequisites can be met and the workload is relatively balanced. Students in reserved seats will have specific places reserved for them in these courses, creating a workable schedule.

Students intending to do these courses in one year without being admitted to the Engineering Transfer program should also try to follow this schedule, but variations may be necessary.

Semester I

Semester II

Note 1: Unless stated, the minimum grade acceptable in all course prerequisites is a C-.

Note 2: Students applying to UBC-V (UBC Vancouver) should substitute CMNS 251 with a humanities/social science elective approved by UBC-V. Students should see an Academic Advisor for more information.

Note 3: Check with UBC and UVic for the minimum GPA and other details.

Program completion

Second, third, and fourth year are completed at UBC or UVic. Courses may also transfer to alternative institutions. Students must apply formally for admission to the destination institution.

Some students choose to take two years at UFV and take all required courses of the Engineering Transfer program plus their second-year math courses and additional electives before they transfer. However, these students are not admitted to the Engineering Transfer program and do not get reserved seats.

Students with first-year sciences are also allowed to compete for second-year Engineering positions if the UBC or UVic programs are not full. Students should see an Academic Advisor for more details.

Transfer credit

Many of the above courses transfer individually to other universities offering engineering programs. Academic Advisors should be consulted to determine the transferability of each course to the university of interest. UFV offers a number of second-year courses in math and science which also transfer individually.

Undergraduate continuance

Students enrolled in undergraduate courses (courses numbered 100 or higher) must maintain an undergraduate Cumulative Grade Point Average (CGPA) of at least 2.00 to remain enrolled in Good Academic Standing at UFV. Students in Good Academic Standing will have no registration limits placed on them. Failure to meet the minimum CGPA requirement will result in restrictions on registration and may eventually lead to academic suspension from undergraduate studies at UFV. Students on Academic Warning or Academic Probation are limited to registering in 10 credits. For further details, see the Academic standing and undergraduate continuance section of the academic calendar. Academic standing is governed by UFV's Undergraduate Continuance policy (92).

Course listings

For complete details on courses see the course descriptions section.